品/高精度扭力測試機；ap-100.jpg)
本月特價 熱賣產品 貨到付款 現場演示 延長保修 終身維修
|
DI-12-4 Yield Torque Tester
|
|
DI-12 motorized torque tester is designed to find the actual yield tightening torque value for specific thread joints which consist of a variety of thread types, multi-layered material, hole sizes, etc.
The yield value is the point at which the torque angle is no longer linear. Once the yield tightening torque value is found, one can easily determine the proper tightening torque value.
DI-12 also captures the difficult-to-detect first peak dip in actual tightening torque of small screws. DI-12 provides a steady slow speed to capture the very small first peak dip and stops automatically to avoid over tightening.
Torque data can be continuously output via RS-232 enabling you to display a torque profile showing, peak down, yield, and destructive strength torque using data acquisition software. |
|
|
|
Model |
Range |
|
DI-12-SL4 |
0.30 – 35.00 lbf-in |
|
DI-12-SL4oz |
3.0 – 560.0 ozf-in |
|
DI-12-SL4kg |
0.30 – 40.00 kgf-cm |
|
DI-12-SL4cN |
3.0 – 400.0 N-cm |
|
DI-12-SL4N |
0.030 – 4.000 N-m |
|
|
|
|
Auccracy |
±1% F.S., 1LSD |
|
Display |
4 digit LCD Display |
|
Operation |
Both CW and CCW motorized rotation |
|
Measurement Modes |
P-P: Displays PEAK Torque value that will not change until a higher value is measured. T-R: Displays TRANSIENT torque values. RG: Determines peak down and yield torque (CW only) If a peak down torque value is detected, the green indicator will light, and tester rotation will stop automatically. |
|
Test Start Value |
Start of RG Mode can be set in 0.001 N-m increments. |
|
RS-232 Output |
Continuous (9600 baud) output in PP and RG measuring modes. |
|
Auto-power-off |
After 5 minutes of non-use. |
|
Drive |
1/4" Hex |
分享儀器
品/em62經濟型標準耳罩.jpg)
檢測設備/et-2109lsr本質安全型轉速表.jpg)
檢測設備/1015頻閃儀（徳雷羅）.jpg)
隱藏對比框